Make rust and corrosion a thing of the past by ordering a gallon-size can of LPS® 3 Long-Term Premier Rust Inhibitor from SkyGeek. LPS® 3 Long-Term Premier Rust Inhibitor is specially formulated for long-term corrosion protection, keeping your metal parts from rusting when stored. The long-lasting formula protects for up to two years with just a single application. LPS® 3 Long-Term Premier Rust Inhibitor is easily detected as it forms a soft, transparent, waxy film on the surface that it is applied to, sealing out moisture, air, acid, alkali fumes and other potentially corrosive hazards. The rust inhibitor is safe for use on all metals, so one gallon-size can protect all your metal parts.
LPS® 3 Long-Term Premier Rust Inhibitor is easy to apply and while it's safe for all metal surfaces, it can also be used on rubber, fabric, plastics and paints. If it can corrode, LPS® 3 Long-Term Premier Rust Inhibitor can protect it. The unique liquid formula even inhibits exfoliation and filiform corrosion on aluminum surfaces. LPS® 3 Long-Term Premier Rust Inhibitors work hard to displace moisture and have even been deemed acceptable for use in Canadian food processing establishments.
Forms a transparent, soft, waxy film for protection and lubrication Inhibits rust and corrosion; protects steel parts indoors for up to 2 years Inhibits exfoliation and filiform corrosion of aluminum Penetrates to displace moisture Does not contain chlorinated solvents or silicone Nonconductive Safe on most surfaces Meets NSF requirements for H2 Registration: #129027 (aerosol), #059849 (bulk) Accepted by the Canadian Food Inspection Agency - Category n1 Inverta Spray Valve
Meets or Exceeds these Airframe Specifications Boeing BMS 3-23 G Type II DMS 2150 Lockheed G39.2004 Mil-PRF-16173D Grade 2 Class 1 Airbus TN A.007.10138 Type 1 Grade 2 NSF Registered Category Code H2 Registration No.: # 129027 Canadian Food Inspection Agency (CFIA) approved
Appearance/Physical State: Opaque brown liquid Dielectric Strength (ASTM D-877): 19.5 kv Flash Point (TCC): 100°F(40°C) minimum HMIS: 1,2,0 Humidity Cabinet Test(ASTM D 1748):: No rust on 1029 steel panels after 30 days Pour Point: 0°F(-18°C) Propellant: Carbon Dioxide Salt Spray Cabinet Test (ASTM-D-117): No corrosion on 2024-T3 aluminum panels after 1500 hours Specifc Gravity(water=1): 0.82–0.86 Typical Dried Film Thickness:: 50-100 microns(2-4 mils) Viscosity at 25°C: 200-600 cps
Safety Data Sheet